BS EN ISO 3949:2020 pdf free.Plastics hoses and hose assemblies -Textile-reinforced types for hydraulic applications – Specification.
BS EN ISO 3949 This document specifies requirements for three types of textile-reinforced thermoplastics hoses and hose assemblies of nominal size from 3,2 to 25. Each type is divided into two classes dependent on electrical conductivity requirements.They are suitable for use with: 一oil-based hydraulic fluids HH, HL, HM, HR and HV as defined in ISO 6743-4 at temperatures ranging from -40 °C to +93 °C; 一water-based fluids HFC, HFAE, HFAS and HFB as defined in ISO 6743-4 at temperatures ranging from0°Cto+60°C一water at temperatures ranging from 0 °C to +60 °C. This document does not include any requirements for end fittings. It is limited to the performance of hoses and hose assemblies.NOTE It is the responsibility of the user, in consultation with the hose manufacturer, to establish the compatibility of the hose with the fluid to be used.The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.ISO 1402, Rubber and plastics hoses and hose assemblies一Hydrostatic testing ISO 1817, Rubber; vulcanized or thermoplastic一Determination of the effect of liquids ISO 4671, Rubber and plastics hoses and hose assemblies一Methods of measurement of the dimensions of hoses and the lengths of hose assemblies
ISO 6803, Rubber or plastics hoses and hose assemblies一Hydraulic-pressure impulse test without flexing ISO 7326:2016, Rubber and plastics hoses一 Assessment of ozone resistance under static conditions ISO 8330, Rubber and plastics hoses and hose assemblies – Vocabulary ISO 10619-1:2017, Rubber and plastics hoses and tubing 一Measurement of flexibility and stiffness – Part 1: Bending tests at ambient temperature ISO 10619-2:2017, Rubber and plastics hoses and tubing – – Measurement of flexibility and stiffness 一 Part 2: Bending tests at sub-ambient temperatures ISO 17165-1, Hydraulic fluid power – Hose assemblies – Part 1: Dimensions and requirements.BS EN ISO 3949 pdf downlaod.
BS EN ISO 3949:2020 pdf free
ATTENTION:
I REALLY NEED YOUR SUPPORT.THANKS A LOT.