BS EN 2510:2019 pdf free.Aerospace series – Aluminium alloy 2024– T42 – Drawn tubes for structural applications.
1 Scope This document specifies the requirements relating to: Aluminium alloy 2024-T42 Drawn tubes for structural applications for aerospace applications. 2 Normative references The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. EN 2002-10, Aerospace series一Test methods for metallic materials一Part 10: Tube flattening test 1 EN 2070-1, Aerospace series Aluminium and aluminium alloy wrought products 一Technical specification一Part 1: General requirements EN 2070-4, Aerospace series 一Aluminium and aluminium alloy wrought products 一 Technical specification- Part 4: Tube for structures EN 2257, Aerospace series一Circular tubes for structures in aluminium and aluminium alloys一Diameter 6mm≤D≤100 mm一Thickness 1 mm≤a≤6 mm一Dimensions EN 4258, Aerospace series一Metallic materials 一General organization of standardization一 Links between types of EN standards and their use EN 4500-2, Aerospace series 一Metallic materials一Rules for drafting and presentation of material standards一Part 2: Specific rules for aluminium, aluminium alloys and magnesium alloys 1.  3 Terms and definitions No terms and definitions are listed in this document. ISO and IEC maintain terminological databases for use in standardization at the following addresses: ● IEC Electropedia: available at http:/ /www.electropedia.org/ ● ISO Online browsing platform: available at http://www.iso.org/obp 4 Requirements Table 1 shows the requirements for aluminium alloy 2024-T42 一Drawn tubes for structural applications.BS EN 2510 pdf download.