BS EN 3645-005:2019 pdf free.Aerospace series – Connectors, electrical, circular, scoop-proof, triple start threaded coupling, operating temperature 175 °C or 200 °C continuous .
The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. EN 3645-001, Aerospace series 一Connectors, electrical, circular, scoop-proof, triple start threaded coupling, operating temperature 175。C or 200 °C continuous一Part 001: Technical specification EN 3645-002, Aerospace series 一Connectors, electrical, circular, scoop-proof, triple start threaded coupling, operating temperature 175。C or 200 °C continuous一Part 002: Specification of performance and contact arrangements EN 3645-006, Aerospace series 一Connectors, electrical, circular, scoop-proof, triple start threaded coupling, operating temperature 175 °C or 200 °C continuous一Part 006: Protective cover for receptacle一Product standard EN 3645-008, Aerospace series 一Connectors, electrical, circular, scoop-proof, triple start threaded coupling, operating temperature 175 °C or 200 °C continuous一Part 008: Non release plug with grounding ring一Product standard EN 3645-011, Aerospace series 一Connectors, electrical, circular, scoop-proof, triple start threaded coupling, operating temperature 175 °C or 200 °C continuous一Part 011: Lanyard release plug with grounding fingers- Type 1一Product standard EN 3645-012, Aerospace series 一Connectors, electrical, circular, scoop-proof, triple start threaded coupling, operating temperature 175 °C or 200 °C continuous一Part 012: Lanyard release plug with grounding fingers一Type 2 – – Product standard MIL-DTL-38999/25, Connector, electrical, circular, threaded, receptacle, solder mounting, hermetic, hermetic solder contacts, series II, metric 1)For the purposes of this standard, the terms and definitions given in EN 3645-001 apply.4.2 Materials and surface treatment See Table 3. 4.3 Recommended panel cut-out See Figure 2 and Table 2. Dimensions and tolerances are in millimetres. ISO and IEC maintain terminological databases for use in standardization at the following addresses: ● IEC Electropedia: available at http://www.electropedia.org/ ● ISO Online browsing platform: available at http://www iso.org/obp 6 Marking According to EN 3645-001. 7 Technical specification According to EN 3645-001.NOTE If necessary, the code 19005 shall be placed between the description block and the identity block.BS EN 3645-005 pdf download.