AS NZS 60929:2020 pdf free.AC and/or DC-supplied electronic control gear for tubular fluorescent lamps一Performance requirements (IEC 60929:2011+AMD1:2015 CSV (ED.4.1) MOD).
4 General notes on tests
4,1 Tests according to this standard are type tests.
NOTE The requirements and tolerances permitted by this standard are based on the testing of a type test sample submitted by the manufacturer for that purpose. In principle this type test sample should consist of units having characteristics typical of the manufacturer’s production and be as close to the production centre point values as possible.
It may be expected with the tolerances given in this standard that products manufactured in accordance with the type test sample will ensure compliance with the standard for the majority of the production. However, due to the production spread, it is inevitable that there will sometimes be products outside the specified tolerances. For guidance on sampling plans and procedures for inspection by attributes, see IEC 60410.
4.2 The tests are carried out in the order of the clauses, unless otherwise specified.
4.3 One control gear is submitted to all tests, unless otherwise stated.
4.4 In general, all tests are made on each type of control gear or where a power range of similar control gear is involved, for each rated power in the range or on a representative selection from the range as agreed with the manufacturer.
4.5 The tests are made under the conditions specified in Annex A. Lamp data sheets not published in an IEC publication shall be made available by the lamp manufacturer.
4.6 All control gear specified in this standard shall comply with the requirements of
IEC 61347-2-3.
4.7 Attention is drawn to lamp performance standards which contain “information for control gear design”; this should be followed for proper lamp operation; however, this standard does not require the testing of lamp performance as part of the type test approval for control gear.AS NZS 60929 pdf download.