AS pdf free download - Page 2 of 51

AS ISO 7240.8:2018 pdf free – Point-type fire detectors using a carbon monoxide sensor in combination with a heat sensor

AS ISO 7240.8:2018 pdf free.Fire detection and alarm systems Part 8: Point-type fire detectors using a carbon monoxide sensor in combination with a heat sensor. 5.1.5 Measurement of CO response value 5.1.5.1 Install the specimen for which the CO response value is to be measured in a gas test chamber, as specified in Annex A, in its normal operating position,...

09-08

Download

AS 8001:2021

AS 8001:2021 pdf free.Fraud and corruption control. 2.5 Line management Organizations shall communicate to all line managers a mandatory accountability for promptly reporting fraud and corruption matters that come to their attention. Organizations shall ensure that line management personnel are fully aware that managing fraud and corruption is as much part of their responsibility as managing other types of enterprise...

09-08

Download

AS 5227.1:2021 pdf free – Cranes – Requirements for mechanisms Part 1: General

AS 5227.1:2021 pdf free.Cranes - Requirements for mechanisms Part 1: General (ISO 10972-1:1998, MOD). 4.3 Couplings 4.3.1 General Selection of the type of coupling shall be made on the basis of the general design of the mechanism, its use and performance required in order to avoid vibrations and unwanted reactions. Alignment shall comply with the supplier’s instructions. When necessary, rotating...

09-08

Download

AS ISO 9248:2021 pdf free – Earth-moving machinery

AS ISO 9248:2021 pdf free.Earth-moving machinery - Units for dimensions, performance and capacities, and their measurement accuracies. 1 Scope This International Standard specifies basic units, symbols and tolerances for the measurements of general machine dimensions, performance and capacities of earth-moving machinery as defined in ISO 6165. It does not cover methods and instrumentation to be used. 2 Normative reference The...

09-08

Download

AS IEC 60060.2:2018 pdf free High-voltage test techniques Part 2: Measuring systems

AS IEC 60060.2:2018 pdf free.High-voltage test techniques Part 2: Measuring systems. According to the ISO/IEC Guide 98-3, the uncertainty of a measurement is determined by combining the uncertainty contributions of Type A and Type B (see 5.10, 5.11 and Annex A). The contributions are obtained from measurement results, from manufacturers’ handbooks, calibration certificates and from estimating reasonable values of the...

09-08

Download

AS ISO 8813:2021

AS ISO 8813:2021 pdf free.Earth-moving machinery- Lift capacity of pipelayers and wheeled tractors or loaders equipped with side boom. 4.3.2 Wheeled machines Preliminary calculations shall be made using load overhang lines defined in 3.5 with the machine steered straight ahead, steered fully left, and steered fully right. These preliminary calculations shall be used to select the steering position that results...

09-08

Download

AS 4055:2021

AS 4055:2021 pdf free.Wind loads for housing. 1.3 Normative references The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. NOTE Documents referenced for informative purposes are listed in the Bibliography. AS/NZS 1170.2, Structural design actions, Part 2: Wind actions 1.4 Terms and definitions For...

09-08

Download

AS 4386:2018 pdf free – Cabinetry in the built-in environment- Commercial and domestic

AS 4386:2018 pdf free.Cabinetry in the built-in environment- Commercial and domestic. 6.3.4 Worktop materials Where plastic laminated worktops are used they shall be manufactured from moisture resistant board substrate and covered with a high-pressure laminate in accordance with the ISO 4586 series. The underside of the worktop immediately above and extending for a distance of 150 mm either side of...

09-08

Download

AS 4439.2:2019 pdf free – Preparation of leachates – Zero headspace procedure

AS 4439.2:2019 pdf free.Wastes, sediments and contaminated soils Part 2: Preparation of leachates - Zero headspace procedure. WARNING — SAFETY PRECAUTIONS AS DEFINED IN AS 2243.1, AS 2243.2 AND AS 2243.3 SHOULD BE TAKEN. Sufficient sample solids shall be present to provide enough leachate to support each of the necessary analyses, taking into account the limits of detection of the...

09-08

Download

AS 3668:2019 pdf free – Flexible itermediate bulk containers

AS 3668:2019 pdf free.Flexible itermediate bulk containers- Non-dangerous goods. 4 Materials, design and construction requirements 4.1 Materials FIBCs may be manufactured from a considerable variety of sheet and woven materials. The properties of the selected materials may be further modified by suitable additives, e.g. to improve the exposure life and strength and to reduce the effect of static electricity. All...

09-08

Download