BS 5709:2018 pdf free download.Gaps, gates and stiles - Specification. The United Kingdom is noted for the variety of structures on routes with public access, and historic structures should be respected. New structures need to be effective for the purpose for which they are installed, and traditional forms of structure may be used if they provide good access for all...
AS/NZS 1605.3:2018 pdf free download
AS/NZS 1605.3:2018 pdf free download.Methods for sampling and analysing timber preservatives and preservative-treated timber - Part 3: Analysis methods for determination of preservative retention. This Standard specifies analysis methods for determining preservative retention in preservative-treated wood products. The calculations necessary for determining compliance with the requirements specified in the AS/NZS 1604 series and NZS 3640 are outlined. 1.2 APPLICATION This...
AS/NZS 1605.2:2018 pdf free download
AS/NZS 1605.2:2018 pdf free download.Methods for sampling and analysing timber preservatives and preservative-treated timber - Part 2: Determination of preservative penetration by spot test. AS/NZS 1605.2:2018 sets out the method for determining the penetration of preservative into preservative-treated wood products. It deals with the preparation of material for testing and the methods for determining the penetration of creosote, boron, copper...
AS 4744.1-2000 pdf free download
AS 4744.1-2000 pdf free download.Steel shoring and trench lining equipment - Part1:Design. 1.1 SCOPE This Standard specifies the requirements for steel shoring and trench lining systems assembled completely from prefabricated components. It includes requirements for the design. construction and intended use of such systems. 1.2 APPLICATION This Standard applies to all new shoring and trench lining systems. All systems shall...
AS 2898.2-2003 pdf free download
AS 2898.2-2003 pdf free download.Radar speed detection - Part2:Operational procedures. 1.1 SCOPE This Standard sets out the procedures to be followed when using a radar device to measure the speed of a target for law enforcement or for scientific measurement. 1.2 OBJECTIVE The objective of this Standard is to provide operational requirements for radar speed detection devices and training of...
AS 1742.9-2000 pdf free download
AS 1742.9-2000 pdf free download.Manual Of Uniform Traffic Control Devices - Part 9:Bicycle Facilities. This Standard specifies requirements for the signs, pavement markings and other devices to be applied to bicycle facilities both on the road and on paths separate from the road, either for the exclusive use of bicycles or joint use with other users. The Standard includes recommendations...
AS/NZS 2341.0:2002 pdf free download
AS/NZS 2341.0:2002 pdf free download.Methods of testing bitumen and related roadmaking products part 0:General introduction and list of Standards. GENERAL INTRODUCTION This Standard was prepared by the Joint Standards Australia/Standards New Zealand Committee CH-025 Bitumen and Related Products for Roadmaking, as part of an overall program of revision and updating of the following series of products Standards related to bitumen:...
AS 2341.16-1994 pdf free download
AS 2341.16-1994 pdf free download.Methods of testing bitumen and related roadmaking products - Part6:Determination of flashpoint of cutback bitumen. I. SCOPE This Standard sets out a procedure for the determination of the closed flashpoint of cutback bitumens when the llashpoint does not exceed 110°C. NOTE: The results obtained do not differ significantly from the minimum flashpoint of the material determined...
AS 3568-1999 pdf free download
AS 3568-1999 pdf free download.Oils for reducing the viscosity of residual bitumen for pavements. 1. SCOPE This Standard sets out the requirements for hydrocarbon oils, derived from refined crude oil, to be used for reducing the viscosity of bitumen in sprayed work and in the preparation of bituminous cold mixes and fluxed asphalt. 3 DEFINITIONS For the purpose of this...
AS/NZS 1080.3:2000 (R2016) pdf free download
AS/NZS 1080.3:2000 (R2016) pdf free download.Timber - Methods of test Density. 1 SCOPE AND FIELD OF APPLICATION This International Standard specifies a method for determining the density (ratio of mass to volume) of wood for physical and mechanical tests both at the moisture content at the time of test and in the absolutely dry condition, as well as the conventional...