AS IEC 60060.1:2018 pdf free.High-voltage test techniques Part 1: General definitions and test requirements.
4 General requirements
4.1 General requirements for test procedures
The test procedures applicable to particular types of test objects, for example, the test voltage, the polarity to be used, the preferred order if both polarities are to be used, the number of applications and the interval between applications shall be specified by the relevant Technical Committee, having regard to such factors as:
— the required accuracy of the test results;
— the random nature of the observed phenomena;
— any polarity dependence of the measured characteristics and
— the possibility of progressive deterioration with repeated voltage applications.
At the time of a test, the test object shall be complete in all essential details, and it should have been processed in the normal manner for similar equipment.
At the time of a test, the test object should have become acclimatised as much as practicable to the ambient atmospheric conditions of the test area. The period allocated to reach equilibrium should be recorded.
4.2 Arrangement of the test object in dry tests
The disruptive-discharge characteristics of a test object with external insulation may be affected by its general arrangement (for example, proximity effects such as distance in air from other live or earthed structures, height above ground level and the arrangement of its high-voltage lead). The general arrangement should be specified by the relevant Technical Committee.
NOTE 1 A clearance to extraneous structures not less than 1 ,5 times the length of the shortest possible discharge path on the test object usually makes such proximity effects negligible. In wet or pollution tests, or wherever the voltage distribution along the test object and the electric field around its energized electrode are sufficiently independent of external influences, smaller clearances may be acceptable, provided that discharges do not occur to extraneous structures.
NOTE 2 In the case of a.c. or positive switching-impulse voltage tests above 750 kV (peak) the influence of an extraneous structure may be considered as negligible if its distance from the energized electrode is also not less than the height of this electrode above the ground plane. A guide for recommended minimum clearance is given in Figure 1, as a function of the highest test voltage. Significant shorter clearances may be suitable in individual cases. However, an experimental adaptation or a field calculation, taking into account a voltage dependent maximum field strength as described in the literature [1, 2]1, is recommended.AS IEC 60060.1 pdf download.