BS 8607:2014 pdf free.Mechanically operated push-button locksets – Requirements and test methods.
BS 8607 This British Standard specifies requirements and test methods for durability, strength and function of mechanically operated push-button locksets and their locking plates for use on doors, window doors and entrance doors in buildings.This British Standard includes requirements for locksets intended for use on fire-resisting and smoke control doors. It does not specify requirements for locksets intended for use on final exit doors on escape routes, which are covered in BS EN 179.The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.BS 7398:1991, Specification for hand hacksaw frames BS EN 1303:2005, Building hardware – Cylinders for locks – Requirements and test methods BS EN 1906:2012，Building hardware一Lever handles and knob furniture一Requirements and test methodsBS EN 12209:2003, Building hardware – Locks and latches – Mechanically
operated locks, latches and locking plates – Requirements and test methods PAS 24:2012, Enhanced security performance requirements for doorsets and windows in the UK – External doorsets and windows intended to offer a level of security suitable for dwellings and other buildings exposed to comparable risk.When tested in accordance with the methods specified in the relevant subclauses of BS EN 12209:2003, BS EN 1906:2012 or PAS 24:2012, as listed in Table 1, adapted as appropriate (see Note 1), the lockset shall meet the minimum requirements for the appropriate application grade as specified in Table 1. Test sampling and sequencing shall be exactly as stated in the relevant standard, except that there need be only one sample/test for each parameter. NOTE 1 The requirements and associated test methods in BS EN 12209:2003, BS EN 1906:2012 and PAS 24:2012 were written for locks and latches that are not
operated by push-buttons, and therefore might not be fully applicable to locksets. Where this is the case, testing should be carried out as far as possible as specified in the relevant standard, but adapted as appropriate to suit the product under test.NOTE 2 Guidance on the use of locksets on firelsmoke-resisting doors is given in Annex A.BS 8607 pdf download.