BS EN 10028-1:2007 pdf free.Flat products made of steels for pressure purposes – Part1:General requirements.
BS EN 10028-1 specifies general technical delivery conditions for flat products for the construction of pressure equipment.
The general technical delivery conditions in EN 10021 also apply.
NOTE Once this European conformity to the Essential European Standard (Part 1 specific item of equipment. design requirements of this done.
Standard is published in the EU Official Journal (OJEU) under Directive 97/23/EC, presumption of Safety Requirements (ESRs) of Directive 97/23/EC is limited to technical data of materials in this and the other relevant part of the series) and does not presume adequacy of the material to a Consequently, the assessment of the technical data stated in this material standard against the specific item of equipment to verify that the ESRs of Directive 97/23/EC are satisfied, needs to be done.
4 Dimensions and tolerances on dimensions
• The nominal dimensions and tolerances on dimensions for the products shall be agreed at the time of enquiry and order with reference to the dimensional standards listed below.
a) For non-continuously hot-rolled flat products, refer to EN 10029.
Unless otherwise agreed at the time of enquiry and order, class B as specified in EN 10029 shall apply to the tolerance on thickness of plates.
b) For continuously hot-rolled coil or sheet/plate cut from coils (rolled width 600 mm or above) and hot-rolled slit coil in widths less than 600 mm, refer to EN 10051.
c) For hot-rolled narrow strip (rolled width less than 600 mm) refer to EN 10048.
d) For stainless cold-rolled sheet’plate, cold-rolled coil and slit coil (rolled width 600 mm or above) and stainless cold-rolled coil and slit coil in rolled widths less than 600 mm refer to EN ISO 9445.
NOTE EN ISO 9445 contains options providing wider dimensional choice.BS EN 10028-1 pdf download.