BS EN 13834:2020 pdf free.Cookware – Ovenware for use in traditional d omestic ovens.
BS EN 13834 This document specifies safety and performance requirements for items of ovenware for use in domestic ovens. It is applicable to ovenware regardless of material or method of manufacture.It is applicable to products intended for use both on top of the stove and in oven.This document is not applicable to items for single use, throwaway ovenware or ovenware intended for use in a microwave oven only.The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.EN 1183:1997, Materials and articles in contact with foodstuffs- Test methods for thermal shock and thermal shock endurance EN 12875-1:2005, Mechanical dishwashing resistance of utensils一Part 1: Reference test method for domestic articles EN 14916, Domestic cookware一Graphical symbols (pictograms) EN ISO 2064, Metallic and other inorganic coatings 一Definitions and conventions concerning the measurement of thickness (ISO 2064) EN ISO 2360，Non-conductive coatings on non-magnetic electrically conductive base metals-Measurement of coating thickness一Amplitude-sensitive eddy-current method (ISO 2360)EN ISO 2409:2013, Paints and varnishes一Cross-cut test (ISO 2409:2013)EN ISO 28706-2:2017, Vitreous and porcelain enamels一Determination of resistance to chemical corrosion -Part 2: Determination of resistance to chemical corrosion by boiling acids, boiling neutral liquids, alkaline liquids and/or their vapours (ISO 28706-2:2017) ISO 2747, Vitreous and porcelain enamels一Enamelled cooking utensils 一Determination of resistance to thermal shock ISO 4532, Vitreous and porcelain enamels一Determination ofthe resistance of enamelled articles to impact  – Pistol test ISO 13805, Vitreous and porcelain enamels for aluminium一Determination of the adhesion of enamels on
aluminium under the action of electrolytic solution (spall test)It shall be possible to remove it from the body using a force equal to the weight of the lid, + 2 N, in any position at ambient temperature. This test shall be carried out both before and after exposing the product,filled to its usable capacity with water, to a temperature 20 °C above the manufacturer’s maximum
recommended temperature for 1 h and allowing cooling in ambient combinations for 10 min. This test shall also be carried out when the item has cooled to ambient temperature. Where no maximum temperature is recommended, the temperature used shall be 250 °C.The lid shall remain in place throughout the heating and cooling stages. If the lid is fitted with a locking
device, this test shall be carried out with the device disengaged.BS EN 13834 pdf download.