BS EN 15009:2020 pdf free.Aerosol containers一- Compartmented aerosol dispensers.
BS EN 15009 1 Scope This document specifies the relationship between the nominal volume of product and the maximum nominal brimful capacity of the outer container of the compartmented aerosol dispenser.2 Normative references The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.EN 15007, Aerosol containers – Tinplate containers – Dimensions of two and three -piece cans EN 15008, Aerosol containers – Aluminium containers – Dimensions of one-piece cans with 25,4 mm aperture
3 Terms and definitions No terms and definitions are listed in this document.ISO and IEC maintain terminological databases for use in standardization at the following addresses:●ISO Online browsing platform: available at https://www.iso.org/obp ●IEC Electropedia: available at http://www.electropedia.org/ 4 Requirements 4.1 Filling volume The typical standard fllings for compartmented aerosol dispensers can be taken from Figure 1.4.2 Volume of the liquid phase The total volume of the liquid phase at 50 °C, including the propellant gas that is contained separately within the aerosol dispenser, shall not exceed 90 % of the net capacity of the flled and closed aerosol dispenser. 4.3 Nominal quantity declaration The nominal quantity of aerosols shall be declared on the label.For compartmented aerosol dispensers, the nominal quantity does not include the quantity of the propellant (compressed or liquefied gas) which is contained separately within the aerosol dispenser and is not expelled.4.4 Dimensions The dimensions of a tinplate aerosol container shall conform to EN 15007.The dimensions of an aluminium aerosol container shall conform to EN 15008. For both tinplate and aluminium aerosol containers, the dimensions of the height (including contact height) and the 25,4 mm opening may vary to accommodate the insertion of an internal chamber.BS EN 15009 pdf download.