BS EN 2002-21:2019 pdf free

06-09 comment

BS EN 2002-21:2019 pdf free.Aerospace series – Metallic materials – Test methods.
4 Health and safety Resources, test pieces, test samples, test materials, test equipment and test procedures shall comply with
the current health and safety regulations/ laws of the countries where the test is carried out. Where equipment, materials and/or reagents which may be hazardous to health are specified, appropriate precautions in conformity with local regulations/laws shall be taken. Particular attention shall be paid to the health and safety requirements applicable to ionising radiation (Y and X- ray). 5 Principle The method requires the use of X- or gamma-radiography for the detection of discontinuities, using film or real-time techniques, applicable to the testing of metallic materials. See EN ISO 5579. 6 Testing requirements 6.1 Resources The resources shall be appropriate for fixed installation or portable system used on-site.6.1.1 Equipment/plant The following equipment is needed: a) X-ray source[s) and Gamma-ray source[s) with performance parameters appropriate to the material thickness and geometry of the objects to be tested; b) image quality indicators according to EN ISO 19232-1 or EN ISO 19232-2; c) a film processing system; . d) a film density measuring according to EN 444; e) a suitable viewing room with appropriate control of illumination; f) a viewing screen with luminance according to EN 25580 and capable of masking the area of interest; g) radiation monitors calibrated in accordance with national standards; h) a radiation hazard warning system; i) a Gamma-ray source storage facility; j) a building or room with suitable radiation shielding. For real-time radiographic systems: k) a means of remote manipulation;l) electronic viewing/ recording means; m) software; n) image enhancement and assessment tools. 6.1.2 Materials/reagents The following material is required: a) industrial radiographic films according to EN ISO 11699-1; b) film processing chemicals; c) electronic recording means. 6.1.3 Qualification of personnel Testing to the requirements of this document shall only be performed and/or supervised by NDT personnel, qualified and approved in accordance with the requirements of EN 4179. 6.2 Test samples The test sample shall be the casting; or group of castings as specified by the test procedure.BS EN 2002-21 pdf download.

Download It Now Download Here
ATTENTION: I REALLY NEED YOUR SUPPORT.THANKS A LOT.
BS ISO 24081:2021 pdf download BS pdf free download

BS ISO 24081:2021 pdf download

BS ISO 24081:2021 pdf download.Ground cassava leaves (Isombe) — Specification. 1 Scope This document specifies requirements and methods of sampling and testing for ground cassava leaves, which are obtained from the processing of fresh cassava leaves (Manihot esculenta Crantz or Manihot glaziovii) intended for human consumption. 2 Normative references The following documents are referred to in the text in such...
Download

BS EN 1463‑2:2021

BS EN 1463‑2:2021 pdf download.Road marking materials — Retroreflecting road studs Part 2: Road test performance specifications. 4 Test sites and conditions 4.1 General Test sites shall be arranged at suitable locations that meet at least the requirements of 4.2 to 4.5. The test results will depend on the weather, traffic and road surface conditions. These shall all be described...
Download
BS ISO 3739‑2:2021 pdf download BS pdf free download

BS ISO 3739‑2:2021 pdf download

BS ISO 3739‑2:2021 pdf download.Industrial tyres and rims Part 2: Pneumatic tyres (metric series) on 5 degrees tapered or flat base rims — Load ratings. 2 Normative references The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited...
Download

LEAVE A REPLY

Anonymous netizen Fill in information