BS EN 6055:2019 pdf free.Aerospace series – Rod-end with bearing EN 4265 in corrosion resisting steel, external threaded shank – Dimensions and loads – Inch series.
BS EN 6055 This European standard specifies the characteristics of adjustable rod-ends consisting of: a spherical plain bearing, metal to metal, in corrosion resisting steel, wide series (EN 4265); a rod-end with threaded shank with an optional longitudinal groove for locking purposes. They are intended for use in fixed or moving parts of the aircraft structure and their control mechanisms. 2 Normative references The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. EN 2133, Aerospace series一Cadmium plating of steels with specified tensile strength ≤ 1450 MPa, copper, copper alloys and nickel alloys EN 2424, Aerospace series一Marking of aerospace products EN 4265, Aerospace series一Bearing spherical plain, metal to metal in corrosion resisting steel一Wide series一Dimensions and loads一Inch series EN 6099, Aerospace series一Rodends with plain bearing, metal to metal一Technical Specification ISO 1132-1, Rolling bearings – Tolerances – Part 1: Terms and definitions ISO 3161, Aerospace一UN] threads一General requirements and limit dimensions ISO 3353-1, Aerospace一Lead and runout threads一Part 1: Rolled external threads ISO 3353-2, Aerospace一Lead and runout threads – Part 2: Internal threads  ISO 8074, Aerospace一Surface treatment of austenitic stainless steel parts For the purposes of this document, the terms and definitions given in TR 4475 apply. ISO and IEC maintain terminological databases for use in standardization at the following addresses: 一ISO Online browsing platform: available at http://www.iso.org/obp 一IEC Electropedia: available at http://www.electropedia.org/ Symbols of limit deviations are in accordance with definitions of ISO 1132-1. Configuration, dimensions, tolerances and mass shall be according to Figure 1 and Table 1. Table 1 and Table 5: Dimensions and tolerances are expressed in millimetres (inches). Figure 1: Dimensions and tolerances for Ra max. are expressed in μm (μin).  Values apply after surface treatment.Surface roughness shall be according to Figure 1.Surface roughness is measured before surface treatment. BS EN 6055 pdf download.