BS EN 6096:2019 pdf free.Aerospace series – Bearing, spherical plain with self-lubricating liner, extra wide inner ring in corrosion resisting steel – Dimensions and loads- Inch series.
The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. EN 2030，Aerospace series 一Steel X105CrMo17 (1.3544)- – Hardened and tempered- Bars 一De≤150 mm EN 2133, Aerospace series – – Cadmium plating of steels with specified tensile strength ≤ 1 450 MPa,copper, copper alloys and nickel alloys copper, copper alloys and nickel alloys EN 2424, Aerospace series — Marking of aerospace products EN 2755, Aerospace series — Bearing, spherical plain in corrosion resisting steel with selj-lubricating liner — Elevated load at ambient temperature — Technical specification EN 3161, Aerospace series 一Steel FE-PM3801 (X5CrNiCu17-4)- Air melted, solution treated and precipitation treated, bar a or D≤200 mm, Rm≥930 MPa ISO 1132-1, Rolling bearings — Tolerances — Part 1: Terms and definitions ISO 8075, Aerospace — Surface treatment of hardenable stainless steel parts TR 4475, Aerospace series —Bearings and mechanical transmissions for airframe applications — Vocabulary 3 Terms, definitions and symbols For the purposes of this document, the terms and definitions given in TR 4475 apply.， ISO and IEC maintain terminological databases for use in standardization at the following addresses: -ISO Online browsing platform: available at http:/ /www.iso.org/ obp -IEC Electropedia: available at  ttp://www.electropedia.org/ 4 Requirements 4.1 Configuration, dimensions, tolerances and mass Configuration, dimensions, tolerances and mass shall be according to Figure 1, Figure 2 and Table 1. Table 1: dimensions and tolerances are expressed in millimetres (inches). Figure 1: dimensions and tolerances for Ra max. are expressed in um (uin). Values apply after surface treatment. 4.2 Surface roughness Surface roughness shall be according to Figure 1 and Figure 2. Values in micrometer (micro inches), apply prior to surface treatment. Swaging groove shall be described in chapter 5 (designation) with following codes:  Without swaging groove code S: Surface treatment according to ISO 8075 for inner ring before swaging. Cadmium plating of outer ring: 5 um to 8 um (200 μin to 300 μin) according to EN 2133 (cylindrical surface area, chamfers and both end surfaces at manufacture’s option), followed by chromating.
BS EN 6096 pdf download.