BS EN 6098:2019 pdf free.Aerospace series – Rod-end with bearing per EN 6097 in corrosion resisting steel, extra wide inner ring, external threaded shank – Dimensions and loads – Inch series.
The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. EN 2133, Aerospace series 一 Cadmium plating of steels with specified tensile strength ≤ 1450 MPa, copper, copper alloys and nickel alloys EN 2424, Aerospace series一Marking of aerospace products EN 6097, Aerospace series 一Bearing, spherical plain, metal to metal, extra wide inner ring in corrosion resisting steel一Dimensions and loads一Inch series EN 6099, Rod-ends with plain bearing, metal to metal- Technical Specification1 ISO 1132-1, Rolling bearings一Tolerances – Part 1: Terms and definitions ISO 3161, Aerospace一UN] threads – General requirements and limit dimensions ISO 3353-1, Aerospace一Lead and runout threads – Part 1: Rolled external threads ISO 3353-2, Aerospace一Lead and runout threads一Part 2: Internal threads ISO 8074, Aerospace一Surface treatment of austenitic stainless steel parts MIL-PRF-23827, Grease, aircraft and instrument, gear and actuator screw, NATO code No.G 354 metric2 MIL-PRF-46010, Lubricant, solid film, heat cured, corrosion一inhibiting, NATO Code-S-17382 MIL-PRF-81322, Grease, aircraft, general purpose, wide temperature range, NATO Code G-3952 NAS 559, Lock-rod end (key type)3 SAE AMS 5643, Steel, corrosion resistant, bars, wire, forgings, tubing and rings 16Cr-4.0Ni-0.30Cb-4.OCu, Solution and Precipitation Heat Treated (H1025) TR 4475, Bearings and mechanical transmissions for aiframe applications一Vocabulary4.For the purposes of this document, the terms and definitions given in TR 4475 apply. ISO and IEC maintain terminological databases for use in standardization at the following addresses: 一ISO Online browsing platform: available at http://www.iso.org/obp – IEC Electropedia: available at http://www.electropedia.org/ Symbols of limit deviations are in accordance with definitions of ISO 1132-1.Configuration, dimensions, tolerances and mass shall be according to Figure 1 and Table 1 and Table 2. Table 1: Dimensions and tolerances are expressed in millimetres (inches). Figure 1: Dimensions and tolerances for Ra max. are expressed in um (uin). Values apply after surface treatment.BS EN 6098 pdf download.