BS EN 840-3:2020 pdf free.Mobile waste and recycl ling containers.Containers with 4 wheels with a capacity up to 1 300 l with dome lid(s), for trunnion and/or comb lifting devices – Dimensions and design.
BS EN 840-3 This document specifies dimensions and design requirements of mobile waste and recycling containers  with 4 wheels, with dome lid(s) and capacity up to 1 300 l to be used by trunnion and/or comb lifting device.These containers are only approved for the before explicitly mentioned lifting devices.The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
EN 840-5, Mobile waste and recycling containers一Part 5: Performance requirements and test methods EN 840-6, Mobile waste and recycling containers一Part 6: Safety and health requirements EN 1501-5:- -1, Refuse collection vehicles – General requirements and safety requirements- Part 5: Lifting devices for refuse collection vehicles EN ISO 11469, Plastics – Generic identification and marking of plastics products (ISO 11469)5.3 The lid(s) shall cover the opening of the container completely. It/they shall be opened easily by the lifting device during the emptying cycle. It/they shall be made with at least two fixing points and have at least one means of opening.5.4 Handles fitted in front of the trunnion shall have a measurement over the handles of 10 mm less than the actual measurement in Table 1, dimension N° 33. The handles and their location shall also be designed so that they do not harm the operator.5.5 If the container has ribs in the frontal receiver they shall meet the requirements of Figure 4 and Figure 6. 5.6 The container shall have 4 swivel castors. Each swivel castor shall be capable of withstanding 1/3 of the total permissible mass. Each castor shall meet the requirements of EN 840-5. The container shall have facilities for mounting the castor platine according to at least one of the configurations as shown in Figure 7. 5.7 All the surfaces of the container including design features shall be smooth and free of any foreign bodies or flaws. 5.8 The container should have a drain plug. BS EN 840-3 pdf download.