BS EN 840-5:2020 pdf free.Mobile waste and recycling containers.Performance requirements and test methods.
BS EN 840-5 This document gives the test methods for mobile waste and recycling containers according to EN 840-1 to EN 840-4. It also gives the levels to be reached during the tests or after they have been done.This document is applicable to mobile waste and recycling containers with capacities up to 1 7001.The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.EN 840-1, Mobile waste and recycling containers一Part 1: Containers with 2 wheels with a capacity up to 400 lfor comb lifting devices一Dimensions and design EN 840-2, Mobile waste and recycling containers一Part 2: Containers with 4 whees with a capacity up to 1 300 I with flat lid(s), for trunnion and/or comb lifting devices一Dimensions and design EN 840-3, Mobile waste and recycling containers一Part 3: Containers with 4 whees with a capacity up to  1 300 l with dome lid(s), for trunnion and/or comb lifting devices一Dimensions and designEN 840-4, Mobile waste and recycling containers一Part 4: Containers with 4 wheels with a capacity up to 1 700 I with flat lid(s), for wide trunnion or BG- and/or wide comb lifting device一Dimensions and design EN 10142, Continuously hot-dip zinc coated low carbon steels strip and sheet for cold forming一
Technical delivery conditions.Before and after the tests a visual inspection of the container shall be done for the purpose of:a) checking that the container is not damaged and has no visual defect;b} checking that the manufacturing characteristics of the container to be tested are those specified in the standards applying to the container according to EN 840-1 to EN 840-4;
c) comparing the condition of the container before and after the sequence of the tests.After completing the tests some deformation of the container is permissible, however, it shall remain
entirely functional. No obvious damage, cracks, bubbles, large flashes or sharp edges shall be present. No surface defects (unsmooth areas; trails in colour) perceivable from a distance of 1 m by the naked eye shall be visible.BS EN 840-5 pdf downlaod.