BS EN IEC 60904-9:2020 pdf free.Photovoltaic devices. Classification of solar simulator characteristics.
BS EN IEC 60904-9 IEC standards for photovoltaic devices require the use of specific classes of solar simulators deemed appropriate for specific tests. Solar simulators can be either used for performance measurements of PV devices or endurance irradiation tests. This part of IEC 60904 provides the definitions of and means for determining simulator classifications at the required irradiance levels used for electrical stabilization and characterisation of PV devices.
This document is applicable for solar simulators used in PV test and calibration laboratories and in manufacturing lines of solar cells and PV modules. The A+ category is primarily intended for calbration laboratories and is not considered necessary for power measurements in PV manufacturing and in qualification testing. Class A+ has been introduced because it allows for reduction in the uncertainty of secondary reference device calibration, which is
usually performed in a calibration laboratory. Measurement uncertainty in PV production lines will directly benefit from a lower uncertainty of calibration, because production line measurements are performed using secondary reference devices.In the case of PV performance measurements, using a solar simulator of a particular class does not eliminate the need to quantify the influence of the simulator on the measurement by making spectral mismatch corrections and analysing the influences of spatial non-uniformity of iradiance in the test plane and temporal stability of irradiance on that measurement. Test reports for PV devices tested with the simulator report the class of simulator used for the measurement and the method used to quantify the simulator’s effect on the results.
The purpose of this document is to define classifications of solar simulators for use in indoor measurements of terrestrial photovoltaic devices. Solar simulators are classified as A+, A, B or C based on criteria of spectral distribution match, irradiance non-uniformity in the test plane and temporal instability of irradiance. This document provides the required methodologies for determining the classification of solar simulators in each of the categories.
A solar simulator which does not meet the minimum requirements of class C cannot be classified according to this document.BS EN IEC 60904-9 pdf download.