BS EN ISO 10360-5:2020 pdf free.Geometrical product specifications (GPS) -Acceptance and reverification tests for coordinate measuring systems (CMS). This document is not applicable to non-contacting probing systems, which require different testing procedures. The term ‘combined CMM and multi-stylus probing system size error’ has been shortened to ‘multi-stylus size error’ for convenience. This applies in similar cases. If it is desirable to isolate the probing system performance as far as is practical, the influence of the CMM can be minimized but not eliminated. See Annex C for more information. The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.empirical qualification probing system qualification method where the parameters for each probing system attached to an articulation system need to be acquired by measurement of the reference sphere at each angular position used Note 1 to entry: “Reference sphere” is sometimes in industry referred to as “qualification sphere”.effective diameter stylus diameter used with the tip correction vector, for compensating stylus centre points to obtain surface points Note 1 to entry: For the position of the tip correction vector, see ISO 10360-1:2000, Figure 4. Note 2 to entry: The effective stylus tip diameter may be a parameter established by a probing system qualification.multi-stylus probing system fixed orientation single probe that carries star styli or which through stylus changing can present styli at the relevant orientations to be equivalent to a star stylus Note 1 to entry: See Figure 6.In both cases, the user is free to choose the environmental conditions under which the testing in this document will be performed within the manufacturer’s specified limits given in the CMM data sheet. The user is responsible for providing the environment enclosing the CMM as specified by the manufacturer in the CMM data sheet. If the environment does not meet the specifications, then none of the maximum permissible errors in this document can be required to be verified.BS EN ISO 10360-5 pdf download.