BS EN ISO 6414 pdf free.Technical product documentation (TPD)—Technical drawings for glassware.
BS EN ISO 6414 This document establishes rules and conventions for particular use with technical drawings on glassware, for example, laboratory glassware or glassware used in other technical fields. Optical parts are not, however, included herein. The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. ISO 128-34:2001, Technical product drawings一General principles of presentation一Part 34: Views on mechanical engineering drawings ISO 128-50:2001, Technical drawings一- General principles of presentation一Part 50: Basic conventions for representing areas on cuts and sections ISO 129-1:2018, Technical product documentation (TPD)一Presentation of dimensions and tolerances 一 Part 1: General principles ISO 383, Laboratory glassware一Interchangeable conical ground joints ISO 641, Laboratory glassware一Interchangeable spherical ground joints ISO 4793, Laboratory sintered CFritted) filters一Porosity grading, classification and designation ISO 10209, Technical product documentation 一Vocabulary- Terms relating to technical drawings,product definition and related documentation For the purposes of this document, the terms and definitions given in ISO 10209 apply.  ISO and IEC maintain terminological databases for use in standardization at the following addresses: ISO Online browsing platform: available at https://www.iso.org/obp 一IEC Electropedia: available at http://www.electropedia.org/ As a general principle, all glassware shall be drawn as if it were non-transparent [opaque), according to ISO 128 34:2001, Clause 15. In terms of observation of calibration, font and pointer, the outer glassware shall be drawn as a transparency. An example of an inner component and a jacket component glassware drawing is shown in Small sections may be blackened, conforming with ISO 128-50:2001, Clause 8, provided that the distance between their outlines on the actual drawing is not larger than 3 mm. If larger, the section shall be hatched. For thin-walled parts, see 7.1.Interchangeable conical ground joints conforming with the requirements of ISO 383 shall be designated in the manner described therein. Accordingly, no detailed dimensioning of that portion and no indication of the surface finish are required. An example of a code identification for interchangeable conical ground joints is shown in Figure 3.BS EN ISO 6414 pdf download.