DIN EN 16285:2013 pdf free download.Packmittel – Aluminiumtuben – Prifverfahren zur Messung der Verformung des Mantels von Aluminiumtuben (Guillotine-Prafung).
The testing equipment (see Figure 1) shall conform to the information given below. Appropriate data should be chosen where no details are given.With the drop weight locked in position (the situation shown), the lower edge of the drop weight is in line with
the value ‘0’ on the scale. If the drop weight is released and there is no test piece, the drop weight will rest on the base plate. The upper edge of the drop weight then corresponds to the value‘0′ on the scale. The scale is 0 mm to 120 mm. The width of the guide groove is 5,3t0.2 mm. The height of the fall of the drop weight is (115 +1) mm. The thickness of the drop weight is 5t0;1 mm. The total weight is (25士0,1)g or(75+0,1)g. The distance between the drop weight and the limit stop is 32 mm.Testing is carried out on an empty tube at room temperature. The drop weight having the appropriate test weight for the tube diameter as given in the table is raised until the locking lever engages. The tube to be  tested is placed in the prism-shaped support of the base plate in such a way that it abuts against the limit stop. Using the locking lever, the drop weight is released manually so that it drops down. In doing so it compresses
the tube being tested by an amount equal to its deformation value. This is read off the scale. The test report shall contain the following information: a) reference to this standard and, if necessary, a specification for the method of sampling and acceptance of the batch;
b) the complete identification of the batch and of the tubes checked; c) the date of production; d) the number of tubes checked;
e) the number of defects; f) the test result; g) all factors which could have affected the results or all operating details not specified in this standard; h) date, place of test and name of tester.DIN EN 16285 pdf download.