DIN EN 16310:2013 pdf download.Ingenieurdienstleistungen – Terminologie zur Beschreibung von Ingenieurdienstleistungen fur Gebaude, Infrastruktur und Industrieanlagen.
project management professional service that applies (application) methods, tools, techniques and competences to the overall planning, co-ordination and control of a project life cycle, from inception to completion, aimed at meeting a client’s requirements in order to produce a functionally an financially viable project that will be completed on time within authorised cost and to the required quality standards risk effect of uncertainty on objectives [SOURCE: ISO Guide 73] Note 1 to entry: An effect is a deviation from the expected – positive and/or negative. Note 2 to entry: Objectives can have different aspects (such as financial, health and safety, and environmental goals) and can apply at different levels (such as strategic, organisation-wide, project, product and process). Note 3 to entry: Risk is often characterised by reference to potential events and consequences, or a combination of these. validation confirmation, through the provision of objective evidence, that the requirements for a specific intended use or application have been fulfilled [SOURCE EN ISO 9000:2005] Note 1 to entry: The term “validated” is used to designate the corresponding status. Note 2 to entry: The use conditions for validation can be real or simulated. Note 3 to entry: Related terms are: fit for purpose, control, verification. Note 4 to entry: Validation may be described as to check if the right thing is built’.verification confirmation, through the provision of objective evidence, that specified requirements have been fulfilled [SOURCE: EN ISO 9000:2005] Note 1 to entry: The term verified” is used to designate the corresponding status. Note 2 to entry: Confirmation can comprise activities such as: — performing alternative calculations, — comparing a new design specification with a similar proven design specification, — undertaking tests and demonstrations, and — reviewing documents prior to issue. Note 3 to entry: Related terms are: control and validation.Note 4 to entry: Verification may be described as: ‘to check if it is correctly builr or: ‘to check the component or asset is built as required’. Note 5 to entry: Other terms related to life cyde stages and sub-stages can be found in Annex C; descriptions of these additional terms can be found in Annex A .DIN EN 16310 pdf download.