DIN EN 2084:2015 pdf free.Aerospace series -Cables, electrical, general purpose, with conductors in copper or copper alloy -Technical specification.
2 Normative references
The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
EN 2083, Aerospace series — Copper or copper alloy conductors for electrical cables — Product standard
EN 2235, Aerospace series — Single and multicore electrical cables, screened and jacketed — Technical specification
EN 3475-100 (all parts), Aerospace series — Cables, electrical, aircraft use — Test methods — Part 100: General
EN 3838, Aerospace series — Requirements and tests on user-applied markings on aircraft electrical cables
EN 9102, Aerospace series — Quality systems — First article inspection
EN 9133, Aerospace series — Quality management systems — Qualification procedure for aerospace standard parts
ISO 2574, Aircraft — Electrical cables — Identification marking
3 Terms, definitions and symbols For the purposes of this document, the terms, definitions and symbols given in EN 3475-100 apply.
4 Materials and construction of cables
4.1 Conductors  They shall be conform to EN 2083 unless otherwise specified.
4.2 Finished cables The insulation material shall present on uniform circular cross -section throughout the length of the cable. Covering over the insulation shall be treated and applied in such a manner that the cables present a smooth appearance and are able to accept marking.Multiconductors assembly shall be cabled according EN 2235.
5 Required characteristics
The characteristics of the cables, tested according to the methods described hereafter shall comply with the values given in the product standard.
7 Quality assurance
7.1 Qualification
7.1.1 General requirements See EN 9133 and EN 9102.
7.1.2 Qualification conditions The cables shall be submitted for qualification tests on drums, spools or in coils in sufficient lengths, wound evenly and uniformly. Each drum, spool or coil shall have a label containing information given in 9.1.
7.1.3 Qualification tests See Table 1. Multicore cables shall be manufactured with qualified single core cables. Multicore cables shall be tested in accordance with Table 2.
7.1.4 Extension of qualification The qualification granted may be applicable to all the cross-sections in a group in accordance with Table 3 and Table 4 provided that the same construction, processes and materials are used.DIN EN 2084 pdf download.