DIN EN 6081:2018 pdf free.Aerospace series -Rivet, universal head, close tolerance -Inch series.
1 Scope
This document specifies the dimensions, tolerances and mass of rivets with universal head, close tolerance, inch series, for aerospace application.
2 Normative references
The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
EN 2114, Aerospace series – Aluminium 1050A-H14 – Wire forsolid rivets – D ≤ 10mm1 EN 2115,Aerospace series-Aluminium aIloy2ll7-T42 – Wirefor solid rivets— D≤ 10mm EN 2116, Aerospace series – Aluminium alloy 201 7A-T42 – Wire for solid rivets – D ≤ 10mm EN 2117, Aerospace series – Aluminium alloy AL-P5056A (5056A)-H32 – Wire for solid rivets — D ≤ 10mm EN 2424, Aerospace series – Marking of aerospace products EN 3115, Aerospace series – Aluminium alloy 7050-T73 – Wire for solid rivets — D ≤ 10 mm prEN 6104, Aerospace series – Rivets, solid, in aluminium or aluminium alloy – Inch series – Technical Specification’ISO 8080, Aerospace – Anodic treatment of titanium and titanium alloys – Sulfuric acid process AMS 4982, Titanium alloy wire 44.5 Cb2 MIL-C-5541, Chemical conversion coatings on aluminium and aluminium alloys3 NASM 5674, Rivets, structural, aluminium alloy, titanium columbium alloy, general specification for4
3 Terms and definitions
No terms and definitions are listed in this document. ISO and IEC maintain terminological databases for use in standardization at the following addresses:
• IEC Electropedia: available at http://www.electropedia.org/ • ISO Online browsing platform: available at http://www.iso.org/obp
4 Requirements
4.1 Configuration, dimensions, tolerances and mass The configuration shall conform with Figure 1. The dimensions, tolerances and mass shall conform with Figure 1 and Table 1, Table 2, and Table 3. Dimensions and tolerances are expressed in millimetres.
8 Quality management system The manufacturer’s operations shall be an approved production organization for aerospace products and shall demonstrate that it has implemented and is able to maintain a quality management system [e.g. according to EN 9100 or an equivalent aerospace accepted and established quality management system]. The qualification procedure for aerospace standard products [e.g. according to EN 9133 or an equivalent aerospace accepted and established qualification procedure) shall be used and documented according to the specified tests if not otherwise agreed between customer and supplier.DIN EN 6081 pdf download.